EasyManuals Logo

Cisco CATALYST 2960 Command Reference Guide

Cisco CATALYST 2960
800 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
CHAPTER
1-1
Catalyst 2960 Switch Command Reference
OL-8604-03
1
Using the Command-Line Interface
The Catalyst 2960 switch is supported by Cisco IOS software. This chapter describes how to use the
switch command-line interface (CLI) to configure software features.
For a complete description of the commands that support these features, see Chapter 2, “Catalyst
2960 Switch Cisco IOS Commands.”
For information on the bootloader commands, see Appendix A, “Catalyst 2960 Switch Bootloader
Commands.”
For information on the debug commands, see Appendix B, “Catalyst 2960 Switch
Debug Commands.”
For information on the show platform commands, see Appendix C, “Catalyst 2960 Switch
Show Platform Commands.”
For more information on Cisco IOS Release 12.2, see the Cisco IOS Release 12.2 Command
Summary.
For task-oriented configuration steps, see the software configuration guide for this release.
In this document, IP refers to IP version 4 (IPv4).
CLI Command Modes
This section describes the CLI command mode structure. Command modes support specific Cisco IOS
commands. For example, the interface interface-id command only works when entered in global
configuration mode.
These are the main command modes for the switch:
User EXEC
Privileged EXEC
Global configuration
Interface configuration
Config-vlan
VLAN configuration
Line configuration

Table of Contents

Other manuals for Cisco CATALYST 2960

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CATALYST 2960 and is the answer not in the manual?

Cisco CATALYST 2960 Specifications

General IconGeneral
ManageableYes
StackingNo
ModelCatalyst 2960 Series Switches
Power over Ethernet (PoE)Available on some models (IEEE 802.3af)
VLANs255 active VLANs
FeaturesQoS
Operating Temperature32 to 113°F (0 to 45°C)
Relative Humidity10% to 85% non-condensing
Power ConsumptionVaries by model (30W to 400W)

Related product manuals