Cisco CATALYST 2960 Command Reference Guide

B-47
Catalyst 2960 Switch Command Reference
OL-8604-03
Appendix B Catalyst 2960 Switch Debug Commands
debug platform port-asic
debug platform port-asic
Use the debug platform port-asic privileged EXEC command to enable debugging of the port
application-specific integrated circuit (ASIC) driver. Use the no form of this command to disable
debugging.
debug platform port-asic {interrupt | periodic | read | write}
no debug platform port-asic {interrupt | periodic | read | write}
Syntax Description
Note Though visible in the command-line help strings, the stack keyword is not supported.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform port-asic command is the same as the no debug platform port-asic command.
Related Commands
interrupt Display port-ASIC interrupt-related function debug messages.
periodic Display port-ASIC periodic-function-call debug messages.
read Display port-ASIC read debug messages.
write Display port-ASIC write debug messages.
Release Modification
12.2(25)FX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)