Cisco CATALYST 2960 Command Reference Guide

B-4
Catalyst 2960 Switch Command Reference
OL-8604-03
Appendix B Catalyst 2960 Switch Debug Commands
debug backup
debug backup
Use the debug backup privileged EXEC command to enable debugging of the Flex Links backup
interface. Use the no form of this command to disable debugging.
debug backup {all | errors | events | vlan-load-balancing}
no debug backup {all | errors | events | vlan-load-balancing}
Syntax Description
Defaults Backup interface debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug backup command is the same as the no debug backup command.
Related Commands
all Display all backup interface debug messages.
errors Display backup interface error or exception debug messages.
events Display backup interface event debug messages.
vlan-load-
balancing
Display backup interface VLAN load balancing.
Release Modification
12.2(37)SE Added vlan-load-balancing keyword.
12.2(25)FX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)