Cisco CATALYST 2960 Command Reference Guide

2-51
Catalyst 2960 Switch Command Reference
OL-8604-03
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
cluster commander-address
cluster commander-address
You do not need to enter this commandfrom a standalone cluster member switch. The cluster command
switch automatically provides its MAC address to cluster member switches when these switches join the
cluster. The cluster member switch adds this information and other cluster information to its running
configuration file. Use the no form of this global configuration command from the cluster member
switch console port to remove the switch from a cluster only during debugging or recovery procedures.
cluster commander-address mac-address [member number name name]
no cluster commander-address
Syntax Description
Defaults The switch is not a member of any cluster.
Command Modes Global configuration
Command History
Usage Guidelines This command is available only on the cluster command switch.
A cluster member can have only one cluster command switch.
The cluster member switch retains the identity of the cluster command switch during a system reload by
using the mac-address parameter.
You can enter the no form on a cluster member switch to remove it from the cluster during debugging or
recovery procedures. You would normally use this command from the cluster member switch console
port only when the member has lost communication with the cluster command switch. With normal
switch configuration, we recommend that you remove cluster member switches only by entering the no
cluster member n global configuration command on the cluster command switch.
When a standby cluster command switch becomes active (becomes the cluster command switch), it
removes the cluster commander address line from its configuration.
mac-address MAC address of the cluster command switch.
member number (Optional) Number of a configured cluster member switch. The range is 0
to 15.
name name (Optional) Name of the configured cluster up to 31 characters.
Release Modification
12.2(25)FX This command was introduced.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)