Cisco CATALYST 2960 Command Reference Guide

B-23
Catalyst 2960 Switch Command Reference
OL-8604-03
Appendix B Catalyst 2960 Switch Debug Commands
debug matm move update
debug matm move update
Use the debug matm move update privileged EXEC command to enable debugging of MAC
address-table move update message processing.
debug matm move update
no debug matm move update
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug matm move update command is the same as the no debug matm move update command.
Related Commands
Release Modification
12.2(25)SED This command was introduced.
Command Description
mac address-table
move update {receive |
transmit}
Configures MAC address-table move update feature on the switch.
show debugging Displays information about the types of debugging that are enabled.
show mac
address-table move
update
Displays the MAC address-table move update information on the switch.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)