Cisco CATALYST 2960 Command Reference Guide

B-24
Catalyst 2960 Switch Command Reference
OL-8604-03
Appendix B Catalyst 2960 Switch Debug Commands
debug monitor
debug monitor
Use the debug monitor privileged EXEC command to enable debugging of the Switched Port Analyzer
(SPAN) feature. Use the no form of this command to disable debugging.
debug monitor {all | errors | idb-update | info | list | notifications | platform | requests | snmp}
no debug monitor {all | errors | idb-update | info | list | notifications | platform | requests | snmp}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug monitor command is the same as the no debug monitor command.
all Display all SPAN debug messages.
errors Display detailed SPAN error debug messages.
idb-update Display SPAN interface description block (IDB) update-trace debug messages.
info Display SPAN informational-tracing debug messages.
list Display SPAN port and VLAN-list tracing debug messages.
notifications Display SPAN notification debug messages.
platform Display SPAN platform-tracing debug messages.
requests Display SPAN request debug messages.
snmp Display SPAN and Simple Network Management Protocol (SNMP) tracing
debug messages.
Release Modification
12.2(25)FX This command was introduced.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)