Cisco CATALYST 2960 Command Reference Guide

2-214
Catalyst 2960 Switch Command Reference
OL-8604-03
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
mls qos map
mls qos map
Use the mls qos map global configuration command to define the class of service
(CoS)-to-Differentiated Services Code Point (DSCP) map, DSCP-to-CoS map, the
DSCP-to-DSCP-mutation map, the IP-precedence-to-DSCP map, and the policed-DSCP map. Use the
no form of this command to return to the default map.
mls qos map {cos-dscp dscp1...dscp8 | dscp-cos dscp-list to cos | dscp-mutation
dscp-mutation-name in-dscp to out-dscp | ip-prec-dscp dscp1...dscp8 | policed-dscp dscp-list
to mark-down-dscp}
no mls qos map {cos-dscp | dscp-cos | dscp-mutation dscp-mutation-name | ip-prec-dscp |
policed-dscp}
Syntax Description cos-dscp dscp1...dscp8 Define the CoS-to-DSCP map.
For dscp1...dscp8, enter eight DSCP values that correspond to CoS values 0
to 7. Separate each DSCP value with a space. The range is 0 to 63.
dscp-cos dscp-list to
cos
Define the DSCP-to-CoS map.
For dscp-list, enter up to eight DSCP values, with each value separated by a
space. The range is 0 to 63. Then enter the to keyword.
For cos, enter a single CoS value to which the DSCP values correspond. The
range is 0 to 7.
dscp-mutation
dscp-mutation-name
in-dscp to out-dscp
Define the DSCP-to-DSCP-mutation map.
For dscp-mutation-name, enter the mutation map name.
For in-dscp, enter up to eight DSCP values, with each value separated by a
space. Then enter the to keyword.
For out-dscp, enter a single DSCP value.
The range is 0 to 63.
ip-prec-dscp
dscp1...dscp8
Define the IP-precedence-to-DSCP map.
For
dscp1...dscp8, enter eight DSCP values that correspond to the IP
precedence values 0 to 7. Separate each DSCP value with a space. The range
is 0 to 63.
policed-dscp dscp-list
to mark-down-dscp
Define the policed-DSCP map.
For dscp-list, enter up to eight DSCP values, with each value separated by a
space. Then enter the to keyword.
For mark-down-dscp, enter the corresponding policed (marked down) DSCP
value.
The range is 0 to 63.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)