Cisco CATALYST 2960 Command Reference Guide

B-35
Catalyst 2960 Switch Command Reference
OL-8604-03
Appendix B Catalyst 2960 Switch Debug Commands
debug platform forw-tcam
debug platform forw-tcam
Use the debug platform forw-tcam privileged EXEC command to enable debugging of the forwarding
ternary content addressable memory (TCAM) manager. Use the no form of this command to disable
debugging.
debug platform forw-tcam [adjustment | allocate | audit | error | move | read | write]
no debug platform forw-tcam [adjustment | allocate | audit | error | move | read | write]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines If you do not specify a keyword, all forwarding TCAM manager debug messages appear.
The undebug platform forw-tcam command is the same as the no debug platform forw-tcam
command.
Related Commands
adjustment (Optional) Display TCAM manager adjustment debug messages.
allocate (Optional) Display TCAM manager allocation debug messages.
audit (Optional) Display TCAM manager audit messages.
error (Optional) Display TCAM manager error messages.
move (Optional) Display TCAM manager move messages.
read (Optional) Display TCAM manager read messages.
write (Optional) Display TCAM manager write messages.
Release Modification
12.2(25)FX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)