Cisco CATALYST 2960 Command Reference Guide

C-9
Catalyst 2960 Switch Command Reference
OL-8604-03
Appendix C Catalyst 2960 Switch Show Platform Commands
show platform layer4op
show platform layer4op
Use the show platform layer4op privileged EXEC command to display platform-dependent Layer 4
operator information.
show platform layer4op {acl | pacl [port-asic] | qos [port-asic]} {and-or | map | or-and | vcu} [
| {begin | exclude | include} expression]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines You should use this command only when you are working directly with a technical support
representative while troubleshooting a problem. Do not use this command unless a technical support
representative asks you to do so.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
acl Display access control list (ACL) Layer 4 operators information.
pacl [port-asic] Display port ACL Layer 4 operators information. The keyword has this meaning:
• port-asic—(Optional) Port ASIC number.
qos [port-asic] Display quality of service (QoS) Layer 4 operators information. The keyword has
this meaning:
• port-asic—(Optional) QoS port ASIC number.
and-or Display AND-OR registers information.
map Display select map information.
or-and Display OR-AND registers information.
vcu Display value compare unit (VCU) register information.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(25)FX This command was introduced.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)