Cisco CATALYST 2960 Command Reference Guide

2-230
Catalyst 2960 Switch Command Reference
OL-8604-03
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
mls qos srr-queue input dscp-map
mls qos srr-queue input dscp-map
Use the mls qos srr-queue input dscp-map global configuration command to map Differentiated
Services Code Point (DSCP) values to an ingress queue or to map DSCP values to a queue and to a
threshold ID. Use the no form of this command to return to the default setting.
mls qos srr-queue input dscp-map queue queue-id {dscp1...dscp8 | threshold threshold-id
dscp1...dscp8}
no mls qos srr-queue input dscp-map
Syntax Description
Defaults Table 2-11 shows the default DSCP input queue threshold map:
Command Modes Global configuration
Command History
queue queue-id Specify a queue number.
For queue-id, the range is 1 to 2.
dscp1...dscp8 Map DSCP values to an ingress queue.
For dscp1...dscp8, enter up to eight values, and separate each value with a
space. The range is 0 to 63.
threshold threshold-id
dscp1...dscp8
Map DSCP values to a queue threshold ID.
For threshold-id, the range is 1 to 3.
For dscp1...dscp8, enter up to eight values, and separate each value with a
space. The range is 0 to 63.
Table 2-11 Default DSCP Input Queue Threshold Map
DSCP Value Queue ID–Threshold ID
0–39 1–1
40–47 2–1
48–63 1–1
Release Modification
12.2(25)FX This command was introduced.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)