Cisco CATALYST 2960 Command Reference Guide

B-21
Catalyst 2960 Switch Command Reference
OL-8604-03
Appendix B Catalyst 2960 Switch Debug Commands
debug mac-notification
debug mac-notification
Use the debug mac-notification privileged EXEC command to enable debugging of MAC notification
events. Use the no form of this command to disable debugging.
debug mac-notification
no debug mac-notification
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug mac-notification command is the same as the no debug mac-notification command.
Related Commands
Release Modification
12.2(25)FX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show mac
address-table
notification
Displays the MAC address notification information for all interfaces or the
specified interface.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)