EasyManuals Logo

Cisco CATALYST 2960 Command Reference Guide

Cisco CATALYST 2960
800 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #659 background imageLoading...
Page #659 background image
A-17
Catalyst 2960 Switch Command Reference
OL-8604-03
Appendix A Catalyst 2960 Switch Bootloader Commands
reset
reset
Use the reset bootloader command to perform a hard reset on the system. A hard reset is similar to
power-cycling the switch, clearing the processor, registers, and memory.
reset
Syntax Description This command has no arguments or keywords.
Command Modes Bootloader
Command History
Examples This example shows how to reset the system:
switch: reset
Are you sure you want to reset the system (y/n)?y
System resetting...
Related Commands
Release Modification
12.2(25)FX This command was introduced.
Command Description
boot Loads and boots up an executable image and enters the command-line
interface.

Table of Contents

Other manuals for Cisco CATALYST 2960

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CATALYST 2960 and is the answer not in the manual?

Cisco CATALYST 2960 Specifications

General IconGeneral
ManageableYes
StackingNo
ModelCatalyst 2960 Series Switches
Power over Ethernet (PoE)Available on some models (IEEE 802.3af)
VLANs255 active VLANs
FeaturesQoS
Operating Temperature32 to 113°F (0 to 45°C)
Relative Humidity10% to 85% non-condensing
Power ConsumptionVaries by model (30W to 400W)

Related product manuals