Cisco CATALYST 2960 Command Reference Guide

B-48
Catalyst 2960 Switch Command Reference
OL-8604-03
Appendix B Catalyst 2960 Switch Debug Commands
debug platform port-security
debug platform port-security
Use the debug platform port-security privileged EXEC command to enable debugging of
platform-dependent port-security information. Use the no form of this command to disable debugging.
debug platform port-security {add | aging | all | delete | errors | rpc | warnings}
no debug platform port-security {add | aging | all | delete | errors | rpc | warnings}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform port-security command is the same as the no debug platform port-security
command.
Related Commands
add Display secure address addition debug messages.
aging Display secure address aging debug messages.
all Display all port-security debug messages.
delete Display secure address deletion debug messages.
errors Display port-security error debug messages.
rpc Display remote procedure call (RPC) debug messages.
warnings Display warning debug messages.
Release Modification
12.2(25)FX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)