EasyManuals Logo

Cisco CATALYST 2960 Command Reference Guide

Cisco CATALYST 2960
800 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #738 background imageLoading...
Page #738 background image
B-70
Catalyst 2960 Switch Command Reference
OL-8604-03
Appendix B Catalyst 2960 Switch Debug Commands
debug spanning-tree switch
debug spanning-tree switch
Use the debug spanning-tree switch privileged EXEC command to enable debugging of the software
interface between the Spanning Tree Protocol (STP) software module and the port manager software
module. Use the no form of this command to disable debugging.
debug spanning-tree switch {all | errors | flush | general | helper | pm | rx {decode | errors |
interrupt | process} | state | tx [decode] | uplinkfast}
no debug spanning-tree switch {all | errors | flush | general | helper | pm | rx {decode | errors |
interrupt | process} | state | tx [decode] | uplinkfast}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug spanning-tree switch command is the same as the no debug spanning-tree switch
command.
all Display all spanning-tree switch debug messages.
errors Display debug messages for the interface between the spanning-tree software
module and the port manager software module.
flush Display debug messages for the shim flush operation.
general Display general event debug messages.
helper Display spanning-tree helper-task debug messages. Helper tasks handle bulk
spanning-tree updates.
pm
Display port-manager event debug messages.
rx Display received bridge protocol data unit (BPDU) handling debug messages. The
keywords have these meanings:
decode—Display decoded received packets.
errors—Display receive error debug messages.
interrupt—Display interrupt service request (ISR) debug messages.
process—Display process receive BPDU debug messages.
state Display spanning-tree port state change debug messages;
tx [decode] Display sent BPDU handling debug messages. The keyword has this meaning:
decode—(Optional) Display decoded sent packets.
uplinkfast Display uplinkfast packet transmission debug messages.
Release Modification
12.2(25)FX This command was introduced.

Table of Contents

Other manuals for Cisco CATALYST 2960

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CATALYST 2960 and is the answer not in the manual?

Cisco CATALYST 2960 Specifications

General IconGeneral
ManageableYes
StackingNo
ModelCatalyst 2960 Series Switches
Power over Ethernet (PoE)Available on some models (IEEE 802.3af)
VLANs255 active VLANs
FeaturesQoS
Operating Temperature32 to 113°F (0 to 45°C)
Relative Humidity10% to 85% non-condensing
Power ConsumptionVaries by model (30W to 400W)

Related product manuals