Cisco CATALYST 2960 - Stack Configuration Files; The master has the saved and running configuration files for the stack. All members periodically receive synchronized copies of the configuration files from the master. If the master becomes unavailable, any member assuming the role of master has the latest configuration files.; System-level (global) configuration settings-such as IP, STP, VLAN, and SNMP settings-that apply to all members; Member interface-specific configuration settings, which are specific for each member

2-170
Catalyst 2960 Switch Command Reference
OL-8604-03
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
location (interface configuration)
location (interface configuration)
Use the location interface command to enter location information for an interface. Use the no form of
this command to remove the interface location information.
location {additional-location-information word | civic-location-id id | elin-location-id id}
no location {additional-location-information word | civic-location-id id | elin-location-id id}
Syntax Description
Defaults This command has no default setting.
Command Modes Interface configuration
Command History
Usage Guidelines After entering the location civic-location-id id interface configuration command, you enter civic
location configuration mode. In this mode, you can enter the additional location information.
Examples These examples show how to enter civic location information for an interface:
Switch(config-if)# int g1/0/1
Switch(config-if)# location civic-location-id 1
Switch(config-if)# end
Switch(config-if)# int g2/0/1
Switch(config-if)# location civic-location-id 1
Switch(config-if)# end
You can verify your settings by entering the show location civic interface privileged EXEC command.
additional-location-information Configure additional information for a location or place.
civic-location-id Configure global civic location information for an interface.
elin-location-id Configure emergency location information for an interface.
id Specify the ID for the civic location or the elin location. The ID
range is 1 to 4095.
word Specify a word or phrase that provides additional location
information.
Release Modification
12.2(40)SE This command was introduced.