Cisco CATALYST 2960 Command Reference Guide

2-639
Catalyst 2960 Switch Command Reference
OL-8604-03
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
snmp trap mac-notification
snmp trap mac-notification
Use the snmp trap mac-notification interface configuration command to enable the Simple Network
Management Protocol (SNMP) MAC address notification trap on a specific Layer 2 interface. Use the
no form of this command to return to the default setting.
snmp trap mac-notification {added | removed}
no snmp trap mac-notification {added | removed}
Syntax Description
Defaults By default, the traps for both address addition and address removal are disabled.
Command Modes Interface configuration
Command History
Usage Guidelines Even though you enable the notification trap for a specific interface by using the snmp trap
mac-notification command, the trap is generated only when you enable the snmp-server enable traps
mac-notification and the mac address-table notification global configuration commands.
Examples This example shows how to enable the MAC notification trap when a MAC address is added to a port:
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# snmp trap mac-notification added
You can verify your settings by entering the show mac address-table notification interface privileged
EXEC command.
added Enable the MAC notification trap whenever a MAC address is added on this
interface.
removed Enable the MAC notification trap whenever a MAC address is removed from this
interface.
Release Modification
12.2(25)FX This command was introduced.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)