Cisco CATALYST 2960 Command Reference Guide

B-37
Catalyst 2960 Switch Command Reference
OL-8604-03
Appendix B Catalyst 2960 Switch Debug Commands
debug platform ip igmp snooping
debug platform ip igmp snooping
Use the debug platform ip igmp snooping privileged EXEC command to enable debugging of
platform-dependent Internet Group Management Protocol (IGMP) snooping. Use the no form of this
command to disable debugging.
debug platform ip igmp snooping {all | di | error | event | group | mgmt | pak | retry | rpc | warn}
debug platform ip igmp snooping pak {ip-address | error | ipopt | leave| query | report | rx | svi
| tx}
debug platform ip igmp snooping rpc [cfg | misc | vlan]
no debug platform ip igmp snooping {all | di | error | event | group | mgmt | pak | retry | rpc |
warn}
Syntax Description all Display all IGMP snooping debug messages.
di Display IGMP snooping destination index (di) coordination remote procedure
call (RPC) debug messages.
error Display IGMP snooping error messages.
event Display IGMP snooping event debug messages.
group Display IGMP snooping group debug messages.
mgmt Display IGMP snooping management debug messages.
pak {ip-address |
error | ipopt | leave |
query
| report | rx |
svi | tx}
Display IGMP snooping packet event debug messages. The keywords have
these meanings:
• ip-address—IP address of the IGMP group.
• error—Display IGMP snooping packet error debug messages.
• ipopt—Display IGMP snooping IP bridging options debug messages.
• leave—Display IGMP snooping leave debug messages.
• query—Display IGMP snooping query debug messages.
• report—Display IGMP snooping report debug messages.
• rx—Display IGMP snooping received packet debug messages.
• svi—Display IGMP snooping switched virtual interface (SVI) packet
debug messages.
• tx—Display IGMP snooping sent packet debug messages.
retry Display IGMP snooping retry debug messages.
rpc [cfg | misc | vlan] Display IGMP snooping remote procedure call (RPC) event debug messages.
The keywords have these meanings:
• cfg—(Optional) Display IGMP snooping RPC debug messages.
• misc—(Optional) IGMP snooping miscellaneous RPC debug messages.
• vlan—(Optional) IGMP snooping VLAN assert RPC debug messages.
warn Display IGMP snooping warning messages.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)