Cisco CATALYST 2960 Command Reference Guide

B-49
Catalyst 2960 Switch Command Reference
OL-8604-03
Appendix B Catalyst 2960 Switch Debug Commands
debug platform qos-acl-tcam
debug platform qos-acl-tcam
Use the debug platform qos-acl-tcam privileged EXEC command to enable debugging of the quality
of service (QoS) and access control list (ACL) ternary content addressable memory (TCAM) manager
software. Use the no form of this command to disable debugging.
debug platform qos-acl-tcam {all | ctcam | errors | labels | mask | rpc | tcam}
no debug platform qos-acl-tcam {all | ctcam | errors | labels | mask | rpc | tcam}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform qos-acl-tcam command is the same as the no debug platform qos-acl-tcam
command.
Related Commands
all Display all QoS and ACL TCAM (QATM) manager debug messages.
ctcam Display Cisco TCAM (CTCAM) related-events debug messages.
errors Display QATM error-related-events debug messages.
labels Display QATM label-related-events debug messages.
mask Display QATM mask-related-events debug messages.
rpc Display QATM remote procedure call (RPC) related-events debug messages.
tcam Display QATM TCAM-related events debug messages.
Release Modification
12.2(25)FX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)