Cisco CATALYST 2960 - Stack Management Connectivity; You manage the stack and the member interfaces through the master. You can use the CLI, SNMP, Network Assistant, and CiscoWorks network management applications. You cannot manage members as individual switches.; Stack Through an IP Address, page 7-15; Stack Through an SSH Session, page 7-15

2-171
Catalyst 2960 Switch Command Reference
OL-8604-03
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
location (interface configuration)
This example shows how to enter emergency location information for an interface:
Switch(config)# int g2/0/2
Switch(config-if)# location elin-location-id 1
Switch(config-if)# end
You can verify your settings by entering the show location elin interface privileged EXEC command.
Related Commands Command Description
link state group Configures the location information for an endpoint.
show location Displays the location information for an endpoint.