Cisco CATALYST 2960 - Page 205

2-179
Catalyst 2960 Switch Command Reference
OL-8604-03
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
mac access-group
Examples This example shows how to apply a MAC extended ACL named macacl2 to an interface:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# mac access-group macacl2 in
You can verify your settings by entering the show mac access-group privileged EXEC command. You
can see configured ACLs on the switch by entering the show access-lists privileged EXEC command.
Related Commands Command Description
show access-lists Displays the ACLs configured on the switch.
show link state group Displays the MAC ACLs configured on the switch.
show running-config Displays the running configuration on the switch. For syntax
information, select Cisco IOS Configuration Fundamentals Command
Reference, Release 12.2 > File Management Commands >
Configuration File Management Commands.