EasyManua.ls Logo

Cisco CATALYST 2960 - Page 381

Cisco CATALYST 2960
800 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-457
Catalyst 2960 Switch Command Reference
OL-8604-03
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
show interfaces
This is an example of output from the show interfaces stats command for a specified VLAN interface.
Switch# show interfaces vlan 1 stats
Switching path Pkts In Chars In Pkts Out Chars Out
Processor 1165354 136205310 570800 91731594
Route cache 0 0 0 0
Total 1165354 136205310 570800 91731594
This is an example of partial output from the show interfaces status command. It displays the status of
all interfaces.
Switch# show interfaces status
Port Name Status Vlan Duplex Speed Type
Gi0/1 notconnect 1 auto auto 10/100/1000BaseTX
Gi0/2 notconnect 1 auto auto 10/100/1000BaseTX
Gi0/3 notconnect 1 auto auto 10/100/1000BaseTX
Gi0/4 notconnect 1 auto auto 10/100/1000BaseTX
Gi0/5 notconnect 1 auto auto 10/100/1000BaseTX
Gi0/6 notconnect 1 auto auto 10/100/1000BaseTX
<output truncated>
This is an example of output from the show interfaces status err-disabled command. It displays the
status of interfaces in the error-disabled state.
Switch# show interfaces status err-disabled
Port Name Status Reason
Gi0/2 err-disabled dtp-flap
This is an example of output from the show interfaces switchport command for a port. Table 2-22
describes the fields in the display.
Note Private VLANs are not supported in this release, so those fields are not applicable.
Switch# show interfaces gigabitethernet0/1 switchport
Name: Gi0/1
Switchport: Enabled
Administrative Mode: dynamic auto
Operational Mode: static access
Administrative Trunking Encapsulation: negotiate
Operational Trunking Encapsulation: native
Negotiation of Trunking: On
Access Mode VLAN: 1 (default)
Trunking Native Mode VLAN: 1 (default)
Voice VLAN: none
Administrative private-vlan host-association:10 (VLAN0010) 502 (VLAN0502)
Administrative private-vlan mapping: none
Administrative private-vlan trunk native VLAN: none
Administrative private-vlan trunk encapsulation: dot1q
Administrative private-vlan trunk normal VLANs: none
Administrative private-vlan trunk private VLANs: none
Operational private-vlan: none
Trunking VLANs Enabled: ALL
Pruning VLANs Enabled: 2-1001
Capture Mode Disabled
Capture VLANs Allowed: ALL
Protected: false
Unknown unicast blocked: disabled
Unknown multicast blocked: disabled
Voice VLAN: none (Inactive)

Table of Contents

Other manuals for Cisco CATALYST 2960

Related product manuals