Cisco CATALYST 2960 Command Reference Guide

2-538
Catalyst 2960 Switch Command Reference
OL-8604-03
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
show pagp
This is an example of output from the show pagp 1 internal command:
Switch> show pagp 1 internal
Flags: S - Device is sending Slow hello. C - Device is in Consistent state.
A - Device is in Auto mode.
Timers: H - Hello timer is running. Q - Quit timer is running.
S - Switching timer is running. I - Interface timer is running.
Channel group 1
Hello Partner PAgP Learning Group
Port Flags State Timers Interval Count Priority Method Ifindex
Gi0/1 SC U6/S7 H 30s 1 128 Any 16
Gi0/2 SC U6/S7 H 30s 1 128 Any 16
This is an example of output from the show pagp 1 neighbor command:
Switch> show pagp 1 neighbor
Flags: S - Device is sending Slow hello. C - Device is in Consistent state.
A - Device is in Auto mode. P - Device learns on physical port.
Channel group 1 neighbors
Partner Partner Partner Partner Group
Port Name Device ID Port Age Flags Cap.
Gi0/1 switch-p2 0002.4b29.4600 Gi0/1 9s SC 10001
Gi0/2 switch-p2 0002.4b29.4600 Gi0/2 24s SC 10001
Related Commands Command Description
clear pagp Clears PAgP channel-group information.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)