C-18
Catalyst 2960 Switch Command Reference
OL-8604-03
Appendix C Catalyst 2960 Switch Show Platform Commands
show platform port-asic
Note Though visible in the command-line help strings, the stack {control | dest-map | learning | messages |
mvid | prog-parser | span | stats [asic number | port number [asic number]] keywords are not
supported.
Command Modes Privileged EXEC
Command History
Usage Guidelines You should use this command only when you are working directly with your technical support
representative while troubleshooting a problem. Do not use this command unless your technical support
representative asks you to do so.
transmit {port-fifo | queue |
supervisor-sram} [asic number |
port number [asic number]]
Display transmit information. The keywords have these meanings:
• port-fifo—Display the contents of the port-FIFO information
register.
• queue—Display the contents of the queue information
register.
• supervisor-sram—Display supervisor SRAM information.
• asic number—(Optional) Display information for the
specified ASIC. The range is 0 to 1.
• port number—(Optional) Display information for the
specified port and ASIC number. The range is 0 to 27, where 0
is the supervisor and 1 to 25 are the ports.
vct [asic number | port number
[asic number]]
Display the VLAN compression table entries for the specified
ASIC or for the specified port and ASIC. The keywords have these
meanings:
• asic number—(Optional) Display information for the
specified ASIC. The range is 0 to 1.
• port number—(Optional) Display information for the
specified port and ASIC number. The range is 0 to 27, where
0 is the supervisor and 1 to 25 are the ports.
version Display version and device type information for port ASICs.
| begin (Optional) Display begins with the line that matches the
expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified
expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(25)FX This command was introduced.
To Next Page
Loading...
