Cisco CATALYST 2960 - Page 790

Index
IN-8
Catalyst 2960 Switch Command Reference
OL-8604-03
ip igmp snooping last-member-query-interval
command
2-147
ip igmp snooping querier command 2-149
ip igmp snooping report-suppression command 2-151
ip igmp snooping tcn command 2-153
ip igmp snooping tcn flood command 2-155
ip igmp snooping vlan immediate-leave command 2-156
ip igmp snooping vlan mrouter command 2-158
ip igmp snooping vlan static command 2-160
IP multicast addresses 2-247
IP phones
auto-QoS configuration
2-13
trusting packets sent from 2-240
IP-precedence-to-DSCP map 2-214
IP source guard
displaying
dynamic binding entries only
2-467
ip ssh command 2-162
J
jumbo frames
See MTU
L
LACP
See EtherChannel
lacp port-priority command
2-164
lacp system-priority command 2-166
Layer 2 traceroute
IP addresses
2-733
MAC addresses 2-730
line configuration mode 1-2, 1-5
Link Aggregation Control Protocol
See EtherChannel
link flap
error detection for
2-102
error recovery timer 2-104
link state group command 2-172
link state track command 2-174
load-distribution methods for EtherChannel 2-266
location (global configuration) command 2-168
location (interface configuration) command 2-170
logging event command 2-175
logging file command 2-176
logical interface 2-111
loopback error
detection for
2-102
recovery timer 2-104
loop guard, for spanning tree 2-652, 2-656
M
mac access-group command 2-178
MAC access-groups, displaying 2-493
MAC access list configuration mode 2-180
mac access-list extended command 2-180
MAC access lists 2-67
MAC addresses
displaying
aging time
2-499
all 2-497
dynamic 2-503
MAC address-table move updates 2-507
notification settings 2-509
number of addresses in a VLAN 2-501
per interface 2-505
per VLAN 2-513
static 2-511
static and dynamic entries 2-495
dynamic
aging time
2-182
deleting 2-41
displaying 2-503
enabling MAC address notification 2-185
enabling MAC address-table move update 2-183