Cisco CATALYST 2960 - Chapter 2 Using the Command-Line Interface; Searching and Filtering Output of show and more Commands; Accessing the CLI; You manage the switch stack and the stack member interfaces through the stack master. You cannot manage stack members on an individual switch basis. You can connect to the stack master through the console port of one or more stack members. Be careful with using multiple CLI sessions to the stack master. Commands that you enter in one session are not displayed in the other sessions. Therefore, it is possible to lose track of the session from which you entered commands.

2-57
Catalyst 2960 Switch Command Reference
OL-8604-03
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
cluster member
Examples This example shows how to add a switch as member 2 with MAC address 00E0.1E00.2222 and the
password key to a cluster. The cluster command switch adds the candidate to the cluster through
VLAN 3.
Switch(config)# cluster member 2 mac-address 00E0.1E00.2222 password key vlan 3
This example shows how to add a switch with MAC address 00E0.1E00.3333 to the cluster. This switch
does not have a password. The cluster command switch selects the next available member number and
assigns it to the switch that is joining the cluster.
Switch(config)# cluster member mac-address 00E0.1E00.3333
You can verify your settings by entering the show cluster members privileged EXEC command on the
cluster command switch.
Related Commands Command Description
show cluster Displays the cluster status and a summary of the cluster to which the
switch belongs.
show cluster candidates Displays a list of candidate switches.
show cluster members Displays information about the cluster members.