Cisco CATALYST 2960 - Configuring the Client; This example uses a Layer 3 SVI interface on VLAN 99 to enable DHCP-based autoconfiguration with a saved configuration:

2-71
Catalyst 2960 Switch Command Reference
OL-8604-03
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
dot1x
Examples This example shows how to globally enable IEEE 802.1x authentication on a switch:
Switch(config)# dot1x system-auth-control
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands Command Description
dot1x critical (global
configuration)
Configures the parameters for the inaccessible authentication bypass
feature on the switch.
dot1x guest-vlan Enables and specifies an active VLAN as an IEEE 802.1x guest VLAN.
dot1x port-control Enables manual control of the authorization state of the port.
show dot1x [interface
interface-id]
Displays IEEE 802.1x status for the specified port.