Cisco DX70 Administrator's Guide

D15362.06 DX70 and DX80 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
121
Cisco DX70 and DX80 Administrator Guide
UserManagement settings
UserManagement LDAP Mode
The video system supports the use of an LDAP (Lightweight Directory Access Protocol)
server as a central place to store and validate user names and passwords. Use this setting
to configure whether or not to use LDAP authentication. Our implementation is tested for
the Microsoft Active Directory (AD) service.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: LDAP authentication is not allowed.
On: For client certificate verification to work when LDAP authentication is enabled, the
codec requires a CA (Certificate Authority) certificate, and the user must have a Client
Certificate that matches their user distinguishing name (DN) in the active directory (AD).
UserManagement LDAP Server Address
Set the IP address or hostname of the LDAP server.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 255)
A valid IPv4 address, IPv6 address or hostname.
UserManagement LDAP Server Port
Set the port to connect to the LDAP server on. If set to 0, use the default for the selected
protocol (see the UserManagement LDAP Encryption setting).
Requires user role: ADMIN
Default value: 0
Value space: Integer (0..65535)
The LDAP server port number.
UserManagement LDAP Encryption
Define how to secure the communication between the video system and the LDAP server.
You can override the port number by using the UserManagement LDAP Server Port setting.
Requires user role: ADMIN
Default value: LDAPS
Value space: LDAPS/None/STARTTLS
LDAPS: Connect to the LDAP server on port 636 over TLS (Transport Layer Security).
None: Connect to LDAP server on port 389 with no encryption.
STARTTLS: Connect to LDAP server on port 389, then send STARTTLS to enable TLS
encryption.
UserManagement LDAP MinimumTLSVersion
Set the lowest version of the TLS (Transport Layer Security) protocol that is allowed.
Requires user role: ADMIN
Default value: TLSv1.2
Value space: TLSv1.0/TLSv1.1/TLSv1.2
TLSv1.0: Support TLS version 1.0 or higher.
TLSv1.1: Support TLS version 1.1 or higher.
TLSv1.2: Support TLS version 1.2 or higher.
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices

System settings

Cisco DX70 Specifications

General

Connectivity	Ethernet, Wi-Fi
Video Standards	H.264
Operating System	Android-based
Power over Ethernet (PoE)	Yes
Microphone	Integrated microphone
Speaker	Integrated
Audio Standards	G.711, G.722
Mounting Options	Wall mount