Cisco DX70 Administrator's Guide

D15362.06 DX70 and DX80 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
83
Cisco DX70 and DX80 Administrator Guide
Macros settings
Macros Mode
Macros allow you to write snippets of JavaScript code that can automate parts of your video
endpoint, thus creating custom behavior. Use of macros is disabled by default, but the first
time you open the Macro Editor you will be asked whether to enable use of macros on the
codec. Use this setting when you want to manually enable, or to permanently disable the
use of macros on the codec. You can disable the use of macros within the Macro Editor.
But this will not permanently disable macros from running, because every time the codec is
reset the macros will be re-enabled automatically.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: Permanently disable the use of macros on this video system.
On: Enable the use of macros on this video system.
Macros AutoStart
All the macros run in a single process on the video endpoint, called the macro runtime. It
should be running by default, but you can choose to stop and start it manually. If you restart
the video system, the runtime will automatically start again if auto start is enabled.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: The macro runtime will not start automatically after a restart of the video system.
On: The macro runtime will start automatically after a restart of the video system.
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices

System settings

Cisco DX70 Specifications

General

Connectivity	Ethernet, Wi-Fi
Video Standards	H.264
Operating System	Android-based
Power over Ethernet (PoE)	Yes
Microphone	Integrated microphone
Speaker	Integrated
Audio Standards	G.711, G.722
Mounting Options	Wall mount