Cisco DX70 - Peripherals Settings; Peripherals Profile Controlsystems

D15362.06 DX70 and DX80 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
98
Cisco DX70 and DX80 Administrator Guide
Peripherals settings
Peripherals Profile ControlSystems
Define if a third-party control system, for example Crestron or AMX, is expected to be
connected to the video system. This information is used by the video system's diagnostics
service. If the number of connected control systems does not match this setting, the
diagnostics service will report it as an inconsistency. Note that only one third-party control
system is supported.
If set to 1, the control system must send heart beats to the video system using xCommand
Peripherals Pair and HeartBeat commands. Failing to do so will cause the in-room control
extensions to show a warning that the video system has lost connectivity to the control
system.
Requires user role: ADMIN, INTEGRATOR
Default value: NotSet
Value space: 1/NotSet
1: One third-party control system should be connected to the video system.
NotSet: No check for a third-party control system is performed.
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices

System settings