D15362.06 DX70 and DX80 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
96
Cisco DX70 and DX80 Administrator Guide
NetworkServices SNMP CommunityName
Define the name of the Network Services SNMP Community. SNMP Community names
are used to authenticate SNMP requests. SNMP requests must have a password (case
sensitive) in order to receive a response from the SNMP Agent in the codec. The default
password is "public". If you have the Cisco TelePresence Management Suite (TMS) you
must make sure the same SNMP Community is configured there too. NOTE: The SNMP
Community password is case sensitive.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 50)
The SNMP community name.
NetworkServices SNMP SystemContact
Define the name of the Network Services SNMP System Contact.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 50)
The name of the SNMP system contact.
NetworkServices SNMP SystemLocation
Define the name of the Network Services SNMP System Location.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 50)
The name of the SNMP system location.
NetworkServices SSH Mode
SSH (or Secure Shell) protocol can provide secure encrypted communication between the
codec and your local computer.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The SSH protocol is disabled.
On: The SSH protocol is enabled.
NetworkServices SSH AllowPublicKey
Secure Shell (SSH) public key authentication can be used to access the codec.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The SSH public key is not allowed.
On: The SSH public key is allowed.
NetworkServices Telnet Mode
Telnet is a network protocol used on the Internet or Local Area Network (LAN) connections.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: The Telnet protocol is disabled. This is the factory setting.
On: The Telnet protocol is enabled.
To Next Page
Loading...
Need help?
General
