Cisco DX70 Administrator's Guide

D15362.06 DX70 and DX80 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
134
Cisco DX70 and DX80 Administrator Guide
Access call information while using the web interface
Call state indicator
The badge indicates the
number of active calls. If
the system is idle, there is
no badge.
Click the indicator to
get more details about
connected calls.
Open the Call Information
window
Click the Call state indicator to open
the Call Information window manually.
As default, the Call Information window
pops up automatically when the video
system receives a call.
Switch incoming call
notifications on or off
Click Ignore incoming call notices,
to decide whether or not the Call
Information window should pop up
automatically when the video system
receives a call.
When the check box is checked, the
Call Information window will not open
automatically.
Open the Call Control page
Click Open Call Control to go straight
to the Call Control page.
Control the call(s)
Relevant control buttons appear in
the Call Information window. Use the
buttons to:
Show call details
Put the call on hold
Answer the call
Disconnect the call
About the call state indicator
The call state indicator shows whether
the system is in a call or not. You may
also be notified about incoming calls.
The call state indicator is available on all
pages except the Call Control page.
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices

Appendices

Cisco DX70 Specifications

General

Connectivity	Ethernet, Wi-Fi
Video Standards	H.264
Operating System	Android-based
Power over Ethernet (PoE)	Yes
Microphone	Integrated microphone
Speaker	Integrated
Audio Standards	G.711, G.722
Mounting Options	Wall mount