Cisco DX70 Administrator's Guide

D15362.06 DX70 and DX80 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
85
Cisco DX70 and DX80 Administrator Guide
Network [1] IEEE8021X Identity
Define the user name for 802.1X authentication.
Requires user role: ADMIN, USER
Default value: ""
Value space: String (0, 64)
The user name for 802.1X authentication.
Network [1] IEEE8021X Password
Define the password for 802.1X authentication.
Requires user role: ADMIN, USER
Default value: ""
Value space: String (0, 50)
The password for 802.1X authentication.
Network [1] IEEE8021X AnonymousIdentity
The 802.1X Anonymous ID string is to be used as unencrypted identity with EAP (Extensible
Authentication Protocol) types that support different tunneled identity, like EAP-PEAP and
EAP-TTLS. If set, the anonymous ID will be used for the initial (unencrypted) EAP Identity
Request.
Requires user role: ADMIN, USER
Default value: ""
Value space: String (0, 64)
The 802.1X Anonymous ID string.
Network [1] IEEE8021X Eap Md5
Define the Md5 (Message-Digest Algorithm 5) mode. This is a Challenge Handshake
Authentication Protocol that relies on a shared secret. Md5 is a Weak security.
Requires user role: ADMIN, USER
Default value: On
Value space: Off/On
Off: The EAP-MD5 protocol is disabled.
On: The EAP-MD5 protocol is enabled (default).
Network [1] IEEE8021X Eap Ttls
Define the TTLS (Tunneled Transport Layer Security) mode. Authenticates LAN clients
without the need for client certificates. Developed by Funk Software and Certicom. Usually
supported by Agere Systems, Proxim and Avaya.
Requires user role: ADMIN, USER
Default value: On
Value space: Off/On
Off: The EAP-TTLS protocol is disabled.
On: The EAP-TTLS protocol is enabled (default).
Network [1] IEEE8021X Eap Tls
Enable or disable the use of EAP-TLS (Transport Layer Security) for IEEE802.1x
connections. The EAP-TLS protocol, defined in RFC 5216, is considered one of the most
secure EAP standards. LAN clients are authenticated using client certificates.
Requires user role: ADMIN, USER
Default value: On
Value space: Off/On
Off: The EAP-TLS protocol is disabled.
On: The EAP-TLS protocol is enabled (default).
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices

System settings

Cisco DX70 Specifications

General

Connectivity	Ethernet, Wi-Fi
Video Standards	H.264
Operating System	Android-based
Power over Ethernet (PoE)	Yes
Microphone	Integrated microphone
Speaker	Integrated
Audio Standards	G.711, G.722
Mounting Options	Wall mount