D15362.06 DX70 and DX80 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
63
Cisco DX70 and DX80 Administrator Guide
Mute
Volume up
We recommend that you back up the log files and configuration of the
video system before you continue with the factory reset.
Factory reset DX70 using the mute and volume
buttons
Follow these steps to factory reset a DX70 on boot up. If the video system
is on, press and hold the power button until the system shuts down before
you continue.
1. Locate the Mute and Volume up buttons (LEDs).
2. Press the power button, and pay attention to the Mute button.
3. When the Mute button has blinked twice, press the Volume up button,
immediately followed by pressing and holding the Mute button for
approximately 4 seconds. During this process the Mute button turns
red for a few seconds.
Wait while the video system reverts to the default factory settings. The
video system restarts automatically when finished. This may take a few
minutes.
When the system has been successfully reset to factory settings, the
Setup assistant starts with the Welcome screen.
Power button
Factory reset the video system (page 3 of 4)
To Next Page
Loading...
Need help?
General
