Cisco Firepower 9300 Command Reference

Commit, Discard, and View Pending Commands
When you enter a configuration command in the CLI, the command is not applied until you enter the
commit-buffer command. Until committed, a configuration command is pending and can be discarded by
entering a discard-buffer command.
You can accumulate pending changes in multiple command modes and apply them together with a single
commit-buffer command. You can view the pending commands by entering the show configuration pending
command in any command mode.
All pending commands are checked for validity. However, if any queued command fails during commit, the
remaining commands are applied; failed commands are reported in an error message.
Note
While any commands are pending, an asterisk (*) appears before the command prompt. The asterisk disappears
when you enter the commit-buffer command.
The following example shows how the prompts change during the command entry process:
Firepower# scope system
Firepower /system # scope services
Firepower /system/services # create ntp-server 192.168.200.101
Firepower /system/services* # show configuration pending
scope services
+ create ntp-server 192.168.200.101
exit
Firepower /system/services* # commit-buffer
Firepower /system/services #
Cisco Firepower 4100/9300 FXOS Command Reference
10
CLI Overview
Commit, Discard, and View Pending Commands

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes