Cisco Firepower 9300 Command Reference

show ipv6-block
To display a list of IPv6 address blocks currently defined for service access, use the show ipv6-block command.
show ipv6-block [[ipv6_address prefix_length {https|snmp|ssh}]|detail]
Syntax Description
(Optional) To display a specific IPv6 address block, enter that address
information:
• The starting address for the IPv6 address block.
• The prefix length; determines the number of addresses in the block. Value
can be 0 to 128.
• The service (HTTPS, SNMP, or SSH) to which the address block is
assigned.
ipv6_address prefix_length
{https|snmp|ssh}
(Optional) Appending the detail keyword displays the address, prefix and
service for each IPv6 block as separate lines.
detail
Command Modes
Services mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
Use this command to list the currently permitted blocks of IPv6 addresses. Up to 25 different blocks can be
configured for each service.
Example
This example shows how to display detailed IPv4 address block information:
FP9300-A # scope system
FP9300-A /system # scope services
FP9300-A /system/services # show ip-block detail
IP Address: 2001:DB8:1::1
Prefix Length: 64
Protocol: https
Permitted IP Block:
IP Address: 0:0:0:0:0:0:0:0
Prefix Length: 0
Protocol: snmp
IP Address: 2001:DB8:0:ABCD::1
Prefix Length: 64
Protocol: ssh
FP9300-A /system/services #
Cisco Firepower 4100/9300 FXOS Command Reference
300
S Commands
show ipv6-block

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes