Cisco Firepower 9300 Command Reference

scope Commands
• scope, on page 124
• scope adapter, on page 126
• scope auto-install, on page 127
• scope auto-macpool, on page 128
• scope cabling, on page 130
• scope callhome, on page 131
• scope chassis, on page 132
• scope cloud-connector, on page 133
• scope default-auth, on page 134
• scope eth-uplink, on page 135
• scope fabric-interconnect, on page 136
• scope fan-module, on page 137
• scope firmware, on page 138
• scope firmware-install, on page 139
• scope ipsec, on page 140
• scope ipv6-config, on page 141
• scope licdebug, on page 142
• scope license, on page 143
• scope monitoring, on page 144
• scope org, on page 145
• scope packet-capture, on page 146
• scope password-profile, on page 147
• scope profile, on page 148
• scope reservation, on page 149
• scope security, on page 150
• scope server, on page 151
• scope service-profile, on page 152
• scope slot, on page 153
• scope ssa, on page 154
• scope system, on page 155
• scope vnic, on page 156
Cisco Firepower 4100/9300 FXOS Command Reference
123

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes