Cisco Firepower 9300 Command Reference

scope eth-uplink
To enter Ethernet uplink mode, use the scope eth-uplink command.
scope eth-uplink
Syntax Description
This command has no arguments or keywords.
Command Modes
EXEC mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
You do not have to enter this mode with a managed object.
Example
This example shows how to enter Ethernet uplink mode:
FP9300-A#scope eth-uplink
FP9300-A /eth-uplink #
Related Commands
DescriptionCommand
Shows Ethernet uplink information.show eth-uplink
Cisco Firepower 4100/9300 FXOS Command Reference
135
S Commands
scope eth-uplink

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes