Cisco Firepower 9300 Command Reference

set account-status
To specify whether a local user account is active or inactive, use the set account-status command.
set account-status {active|inactive}
Syntax Description
Specifies that the local user account is active.active
Specifies that the local user account is disabled.inactive
Command Modes
Local user (/security/local-user) mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
You must be a user with admin or AAA privileges to use this command.
The admin account is always set to active. It cannot be modified.
Example
This example shows how to enter local user mode and deactivate a local user account:
FP9300-A # scope security
FP9300-A /security # scope local-user test_user
FP9300-A /security/local-user # set account-status inactive
FP9300-A /security/local-user* # commit-buffer
FP9300-A /security/local-user #
Related Commands
DescriptionCommand
Specifies the date on which the user account expires.set expiration
Cisco Firepower 4100/9300 FXOS Command Reference
162
S Commands
set account-status

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes