Cisco Firepower 9300 Command Reference

create profile
To add a new Smart Call Home and Smart Licensing destination profile, use the create profile command. If
a profile with the specified name already exists, the command will fail.
To add or edit a destination profile, use the enter profile command. If the specified profile does not exist, it
is created and entered; if the profile exists, it is entered.
You also can use the scope form of this command to enter an existing profile to assign or change properties.
If the profile does not exist, the command will fail.
To delete an existing profile, use the delete form of this command.
create profile name
delete profile name
enter profile name
scope profile name
Syntax Description
The name identifying the destination profile.
name
Command Modes
scope monitoring/scope callhome/
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
When you create a new Smart Call Home profile, you are automatically entered into callhome/profile mode
(monitoring/callhome/profile) with an asterisk indicating the new profile is not yet committed. You can define
the profile, and then commit the new profile information.
After you create a Smart Call Home destination profile, the profile name cannot be changed. You must delete
the profile and create a new one.
Example
This example shows how to create and enter a Smart Call Home destination profile:
firepower # scope monitoring
firepower /monitoring # scope callhome
firepower /monitoring/callhome # enter profile TestProfile
firepower /monitoring/callhome/profile* # commit-buffer
firepower /monitoring/callhome/profile #
Related Commands
DescriptionCommand
Deletes an existing Smart Call Home destination profile.delete profile
In monitoring/callhome mode, sets profile properties.set
Cisco Firepower 4100/9300 FXOS Command Reference
71
A – R Commands
create profile

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes