Cisco Firepower 9300 Command Reference

show https
To display the current HTTPS service configuration, use the show https command.
show https
Syntax Description
This command has no arguments or keywords.
Command Modes
Services mode
Command History
ModificationRelease
Command added.1.1(1)
Example
This example shows how to display the current HTTPS service configuration:
FP9300-A# scope system
FP9300-A /system # scope services
FP9300-A /system/services # show https
Name: https
Admin State: Enabled
Port: 443
Operational port: 443
Key Ring: default
Cipher suite mode: Medium Strength
Cipher suite: ALL:!EDH-RSA-DES-CBC3-SHA:!EDH-DSS-DES-CBC3-SHA:!DES-CBC3-SHA:
!ADH:!3DES:!EXPORT40:!EXPORT56:!LOW:!RC4:!MD5:!IDEA:+HIGH:+MEDIUM:+EXP:+eNULL
Https authentication type: Cred Auth
Crl mode: Relaxed
FP9300-A /system/services #
Related Commands
DescriptionCommand
Specifies the type of authentication for HTTPS access.set https auth-type
Cisco Firepower 4100/9300 FXOS Command Reference
273
S Commands
show https

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes