Cisco Firepower 9300 Command Reference

set local-address
To specify the local IP address for an IPSec connection, use the set local-address command.
set local-address ip_address
Syntax Description
Provide an IPv4 or IPv6 local gateway address for the IPSec connection;
maximum of 510 characters.
ip_address
Command Modes
Connection mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
Use this command and the set remote-address command to define the endpoints of an IPSec connection.
Example
This example shows how to set the local address for an IPSec connection:
FP9300-A # scope security
FP9300-A /security # scope ipsec
FP9300-A /security/ipsec # enter connection testconn
FP9300-A /security/ipsec/connection # set local-address 209.165.201.12
FP9300-A /security/ipsec/connection* # commit-buffer
FP9300-A /security/ipsec/connection #
DescriptionCommand
Creates a new IPSec connection.create connection
Sets the remote IP address for an IPSec connection.set remote-addr
Cisco Firepower 4100/9300 FXOS Command Reference
197
S Commands
set local-address

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes