Cisco Firepower 9300 Command Reference

set admin-state
To enable or disable the administrative state of a Smart Call Home policy, use the set adminstate command.
set admin-state {disabled|enabled}
Syntax Description
Sets the policy administrative state to disabled.disabled
Sets the policy administrative state to enabled.enabled
Command Modes
Policy (monitoring/callhome/policy) mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
Use this command to enable or disable the Call Home policy when a fault or system event matching the
associated cause is encountered.
Example
This example shows how to enter and enable a Call Home policy instance for link-down events:
FP9300-A /monitoring/callhome # enter policy link-down
FP9300-A /monitoring/callhome/policy* # set admin-state enabled
FP9300-A /monitoring/callhome/policy* # commit-buffer
FP9300-A /monitoring/callhome/policy #
Related Commands
DescriptionCommand
Enters a Smart Call Home policy.enter policy
Deletes an existing Smart Call Home policy.delete policy
Displays Call Home configuration or policy information.show
Cisco Firepower 4100/9300 FXOS Command Reference
164
S Commands
set admin-state

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes