Cisco Firepower 9300 Command Reference

scope service-profile
To enter service profile mode, use the scope service-profile command.
scope service-profile {dynamic_uuid|org|server}
Syntax Description
The dynamic UUID of the service profile.
dynamic_uuid
The name of the organization for which the service profile was created; between
1 and 16 characters.
org
The ID of the server for which the service profile was created.
server
Command Modes
EXEC mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
To use this command with the org option, an organization and a service profile for that organization must
already exist.
To use this command with the server option, the server can be specified with its server ID, or the chassis ID
and blade ID (n/n format). The chassis ID is always 1.
Example
This example shows how to enter service profile mode:
FP9300-A # scope service-profile server 1/1
FP9300-A /org/service-profile #
Related Commands
DescriptionCommand
Shows service-profile information.show service-profile
Cisco Firepower 4100/9300 FXOS Command Reference
152
S Commands
scope service-profile

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes