Cisco Firepower 9300 Command Reference

acknowledge server
To acknowledge a server, use the acknowledge server command.
acknowledge server {id|chassis/blade_id}
Syntax Description
To use the server identification number to identify the server to acknowledge,
provide the id.
To use the chassis and blade identification numbers to identify the server to
acknowledge, enter chassis/blade_id in n/n format.
The chassis ID number is always 1.
Note
server
{id|chassis/blade_id}
Command Modes
EXEC
scope chassis/
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
Use the acknowledge server command to verify the existence of a server in your network. For example, you
can acknowledge a server that was recently commissioned to ensure that it exists.
In chassis mode, you can use only the id variable to identify the server to be acknowledged.
Example
The following example shows how to acknowledge a server in module 2 while in chassis mode:
firepower# scope chassis 1
firepower /chassis # acknowledge server 2
firepower /chassis* # commit-buffer
firepower /chassis #
Related Commands
DescriptionCommand
Acknowledges a system fault.acknowledge fault
Verifies the existence of a slot that was recently commissioned.acknowledge slot
The show server commands display a variety of server-related configuration
information.
show server
Cisco Firepower 4100/9300 FXOS Command Reference
28
A – R Commands
acknowledge server

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes