show mac-address
To view MAC address assignments for container instance interfaces, use the show mac-address command.
show mac-address [detail | mac_address]
Syntax Description
Shows the MAC addresses in a non-table format.detail
Shows information about a specific MAC address.
mac_address
Command Modes
scope ssa/scope auto-macpool/
Command History
ModificationRelease
Command added.2.4(1)
Usage Guidelines
This command only applies to container instance interfaces, and it does not show MAC addresses for native
instances.
Example
The following is sample output from the show mac-address command.
firepower# scope ssa
firepower /ssa # scope auto-macpool
firepower /ssa/auto-macpool # show mac-address
Mac Address Item:
Mac Address Owner Profile Owner Name
-------------------- ------------------------ ----------
A2:46:C4:00:00:1E ftd13 Port-channel14
A2:46:C4:00:00:20 ftd14 Port-channel15
A2:46:C4:00:01:7B ftd1 Ethernet1/3
A2:46:C4:00:01:7C ftd12 Port-channel11
A2:46:C4:00:01:7D ftd13 Port-channel14
A2:46:C4:00:01:7E ftd14 Port-channel15
A2:46:C4:00:01:7F ftd1 Ethernet1/2
A2:46:C4:00:01:80 ftd12 Ethernet1/2
A2:46:C4:00:01:81 ftd13 Ethernet1/2
A2:46:C4:00:01:82 ftd14 Ethernet1/2
A2:46:C4:00:01:83 ftd2 Ethernet3/1/4
A2:46:C4:00:01:84 ftd2 Ethernet3/1/1
A2:46:C4:00:01:85 ftd2 Ethernet3/1/3
A2:46:C4:00:01:86 ftd2 Ethernet3/1/2
A2:46:C4:00:01:87 ftd2 Ethernet1/2
A2:46:C4:00:01:88 ftd1 Port-channel21
A2:46:C4:00:01:89 ftd1 Ethernet1/8
The following is sample output from the show mac-address detail command.
firepower# scope ssa
firepower /ssa # scope auto-macpool
firepower /ssa/auto-macpool # show mac-address detail
Cisco Firepower 4100/9300 FXOS Command Reference
306
S Commands
show mac-address
To Next Page
Loading...
Need help?
General
