Cisco Firepower 9300 Command Reference

return
To generate a permanent license return code, use the return command.
return [code]
Syntax Description
(Optional) A license code acquired from the Smart Software Manager.
code
Command Modes
Reservation (/license/reservation) mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
If you no longer need a permanent license, you must officially return it to the Smart Software Manager. If
you do not, the license stays in an in-use state and cannot be used elsewhere.
When you enter this command, the Firepower 4100/9300 chassis immediately becomes unlicensed and moves
to the Evaluation state.
To complete the return, go to https://software.cisco.com/#SmartLicensing-Inventory, locate your Firepower
4100/9300 chassis using its universal device identifier (UDI), and then remove the product instance.
Example
This example shows how to return a permanent license:
FP9300-A# scope license
FP9300-A /license # scope reservation
FP9300-A /license/reservation # return
FP9300-A /license/reservation #
Related Commands
DescriptionCommand
Shows the FXOS universal device identifier (UDI) so you can find your FXOS
instance in the Smart Software Manager.
show license udi
Cisco Firepower 4100/9300 FXOS Command Reference
119
A – R Commands
return

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes