Cisco Firepower 9300 Command Reference

set trustpoint
To set the certificate trustpoint for a keyring, use the set trustpoint command.
set trustpoint trustpoint_name
Syntax Description
Name of a defined trustpoint.
This name can be between 1 and 32 alphanumeric characters. You cannot use
spaces or any special characters other than - (hyphen), _ (underscore), : (colon),
and . (period), and you cannot change this name after the object is saved.
trustpoint_name
Command Modes
scope security/scope keyring/
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
Use this command to specify the trusted point that signed this keyringʼs certificate.
Example
This example shows how to regenerate the keys in the default keyring:
firepower# scope security
firepower /security # scope keyring test-ring
firepower /security/keyring # set trustpoint CiscoCA5
firepower /security/keyring* # commit-buffer
firepower /security/keyring #
DescriptionCommand
Enters an RSA certificate for a keyring.set cert
Specifies the RSA key modulus (SSL key length) in bits.set modulus
Regenerates the RSA keys in the default keyring.set regenerate
Cisco Firepower 4100/9300 FXOS Command Reference
227
S Commands
set trustpoint

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes