Cisco Firepower 9300 Command Reference

show (management interface)
To view current management-interface information, use the show command in fabric interconnect mode.
show
Syntax Description
In fabric interconnect mode, this command has a number of keywords, but entering show without any
modifiers displays the current fabric management-interface information.
Command Modes
scope fabric-interconnect/
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
By default, this command displays IPv4 and IPv6 management-interface information. Appending the detail
keyword displays this interface information, along with some additional fabric-specific information.
Example
This example shows how to display management-interface information:
firepower# scope fabric-interconnect
firepower /fabric-interconnect # show
Fabric Interconnect:
ID OOB IP Addr OOB Gateway OOB Netmask OOB IPv6 Address OOB IPv6 Gateway
Prefix Operability
---- --------------- --------------- --------------- ---------------- ----------------
------ -----------
A 192.0.2.112 192.0.2.1 255.255.255.0 :: :: 64
Operable
firepower /fabric-interconnect #
Related Commands
DescriptionCommand
Enters fabric interconnect mode.scope fabric-interconnect
Shows the current device management IPv6 address.show ipv6-if
Cisco Firepower 4100/9300 FXOS Command Reference
241
S Commands
show (management interface)

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes