Cisco Firepower 9300 Command Reference

show identity
To display a variety of system information, use the show identity command.
show identity {ip-addr|ipv6-addr|iqn|mac-addr|uuid|wwn}
Syntax Description
(Optional) Lists information for all available IP addresses.
The following optional keywords are available:
• IPv4_address—Displays identity information for the specified IPv4
address.
• detail —Displays detailed IPv4 address identity information.
• pool-info —Displays IPv4 address information for the pool. The detail
keyword is also available.
• profile-info —Displays IPv4 address information for the profile. The
detail keyword is also available.
ip-addr
(Optional) Lists information for all available IPv6 addresses.
The following optional keywords are available:
• detail —Displays detailed IPv6-address identity information.
• pool-info —Displays IPv6-address information for the pool. The detail
keyword is also available.
• profile-info —Displays IPv6-address information for the profile. The
detail keyword is also available.
• IPv6_address—Displays identity information for the specified IPv6
address.
ipv6-addr
Cisco Firepower 4100/9300 FXOS Command Reference
274
S Commands
show identity

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes