Cisco Firepower 9300 Command Reference

show ipv6-if
To view current IPv6 management-interface information, use the show ipv6-if command.
Syntax Description
Lists detailed IPv6 management-interface information.detail
Lists finite state machine (FSM) status information related to the IPv6
management interface.
fsm status
Command Modes
IPv6 configuration (fabric-interconnect/ipv6-config) mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
By default, this command displays only IPv6 management-interface information.
Example
This example shows how to display IPv6 management-interface information:
FP9300-A# scope fabric-interconnect
FP9300-A# scope ipv6-config
FP9300-A /fabric-interconnect/ipv6-config # show ipv6-if
Management IPv6 Interface:
IPv6 Address Prefix IPv6 Gateway
----------------------------------- ---------- ------------
2001::8998 64 2001::1
FP9300-A /fabric-interconnect/ipv6-config #
Related Commands
DescriptionCommand
Enters fabric interconnect mode.scope fabric-interconnect
Enters IPv6 configuration mode.scope ipv6-config
Cisco Firepower 4100/9300 FXOS Command Reference
302
S Commands
show ipv6-if

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes